Version 1.6 seems a little better at meshing, last time this was a right mess, and the gears not well defined. They are not bad, and pre mesh (aka point cloud) they looked a lot better than before.
oil-pump.jpg


ariakas,

I didn't think it did "texture" scans in mid quality, but your problem is the angle of the scan and the shadow details affecting the mesh.

propologist

I have a problem with the base of the turntable being misinterpreted, so I don't see all my model, the bottom is cut off, despite recalibrating.
To answer your comment about auto scan. I save my files as Point Cloud, and import into Meshlab and you can clean up in that. You can clean up support areas etc in Free Scan mode, by selecting the ares you don't want included, and that works quite well.