Quote Originally Posted by adamfilip View Post

try and offset the gear on the stepper so it changes the angle of the belt slightly, hopefullly you can do it enough so it doesnt rub, rubbing is bad

i ended up running mine on the left side by the stepper as i already had the stepper wires running, just had to reverse the direction on marlin firmware so it homes left instead of right

let the bed go as far as you can , until right before the wheels hit. plus leave a small gap.

I used a Dremel with Diamond Cut off saw blade. with some water and it worked great if you cut slowly

E3D V6 has a fan with Blue clip that goes over the alum fins of the hotend.. look up the hotend it should be obvious. I would also recommend having a fan blowing on the board. as the stepper drivers can get warm and cause missed steps

I had alot of spare motor wires in my set
Thanks for the wicked fast reply. This helps alot thanks!