Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 11-04-2015, 05:26 PM #1
    dsans1
    dsans1 is offline
    Student
    Join Date
    Nov 2015
    Posts
    12
    Quote Originally Posted by dsans1 View Post
    Fourth, after I have built the printer and calibrated, then what? I have no further instructions on how to proceed. Where to put the powder, how much to use, etc.? Some instructions here would be great.

    Looks like the Sintratec Portal website also has additional instructions that I did not receive in the emailed instructions I have been using. Time to go through them and see if it answers questions 1, 2, 6, and 7...
    Reply With Quote Reply With Quote
  2. 11-04-2015, 05:34 PM #2
    dsans1
    dsans1 is offline
    Student
    Join Date
    Nov 2015
    Posts
    12
    Quote Originally Posted by dsans1 View Post
    Looks like the Sintratec Portal website also has additional instructions that I did not receive in the emailed instructions I have been using. Time to go through them and see if it answers questions 1, 2, 6, and 7...
    Turns out the instructions that were emailed to me, were not complete and now I have found the "Commissioning" Instructions. This answers 4, 5, and 6. Sorry Sintratec for bombing you with emails today!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules