FIlament jam/grind at height.

[dunginhawk]

result of the print was perfect... no issues at all. running another one now... However, this isnt the print that failed that started it all... I got the taz 5 to help with that

I think 2 things may be to blame. 210 degree PLA, and a LONG LONG print... the heat creep i assume

[Roxy]

I think 2 things may be to blame. 210 degree PLA, and a LONG LONG print... the heat creep i assume

I have seen that happen. I have a roll of PLA that needs 210 degrees and if it is a long print and the nozzle is only putting out a tiny amount of filament... It can plug. And the other thing that happens is after a print, the printer shuts everything down. Half the time I have to extract the filament and cut off a few inches because it ends up being too big to feed through the extruder. The good news is that roll is almost used up!!!