Results 1 to 10 of 19
Thread: FIlament jam/grind at height.
Threaded View
-
09-25-2015, 09:25 AM #18
I have seen that happen. I have a roll of PLA that needs 210 degrees and if it is a long print and the nozzle is only putting out a tiny amount of filament... It can plug. And the other thing that happens is after a print, the printer shuts everything down. Half the time I have to extract the filament and cut off a few inches because it ends up being too big to feed through the extruder. The good news is that roll is almost used up!!!
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials