Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 19

Threaded View

  1. 09-22-2015, 01:20 PM #12
    dunginhawk
    dunginhawk is offline
    Engineer
    Join Date
    Jan 2015
    Posts
    445
    yeah, there is a ridge inside this piece, down near the threads, about 1/4 of an inch up inside..its all the way around the inside of the barrell too. i cant push a filament piece past it. of course i dont have a drill bit that matches that hole perfectly to bore it out. or should i even be doing that?
    i cant imagine it isnt 100% necessary to free that debris.
    thoughts?
    Last edited by dunginhawk; 09-22-2015 at 01:48 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules