Results 1 to 10 of 63
Threaded View
-
09-16-2015, 07:33 AM #10
- Join Date
- Jan 2015
- Posts
- 68
Here is a picture of my wiring setup. In short:
(+) from PSU goes to (+) on SSR (Labeled as 1)
(-) from SSR (labeled as 2) goes to one input on the heated bed (They do not have polarity so either is fine)
Unused wire from heated bed comes back to (-) on PSU.
That takes care of the load side.
Connect the labeled connections "3" and "4" on the other side of the SSR to your board while making sure to match the (+) and (-) correctly since the board does have polarity.
This is how I have my 12" heated bed wired up through the SSR on my Rumba board. I then ran the PID config and input the results into my config file. So far after a few prints things are good and my house hasn't burned down.
Good luck.
296E2193-C678-4A75-A540-855D9300EE80.jpgLast edited by Carrot_or_Stick; 09-16-2015 at 11:11 AM. Reason: Provided more information
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials