Results 1 to 10 of 63
Threaded View
-
09-15-2015, 09:41 PM #7
- Join Date
- Jan 2015
- Posts
- 445
so im wiring up my solid state relay, and the common from the PS goes to the input - and the + from the PS goes to the +.
However, coming off of that are 2 black wires, that arent labeled + or - and the bed doesnt seem to care and colins instructions dont have a positive or negative marking...
so thats throwing me off a bit... any help?
Edit: so i just took the + from the same block as the + from the PS and marked it +. so that should be good.. and the same for the common.... so i think the above is resolved.
EDIT :2 = seeing the above may be wrong also... Thomas Sandelar has a good video on wiring these, but its AC... this is obviously a DC relay... still searching
now im not sure how to hook it up to the rumba board... there are no spots to connect those 2 wires that go from the board HB out , in to the relay.... thoughts?
thanksLast edited by dunginhawk; 09-15-2015 at 10:40 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help