Good afternoon all,

Been having a bit of a nightmare with my dreamer - honeymoon period was great with almost zero failed prints - its still great with smaller surface area stuff but no matter what i cannot stop my larger surface prints warping and pulling away from the bed... but thats an issue i am working through and am looking into sourcing a few 6mm pieces of glass and will use glue over the top to hopefully solve my problems.

My main reason for this, my first post, is that the left hand extruder is offset from the right - so much so that a model that would print in the center if printed by the right is almost off the bed when printing with the left.

It hasnt always been like this, all was fine until a print failed last week (printing unattended overnight...) where the object came unattached from the bed resulting in a lot of mid air printing and a tangled mass of filament being discovered in the morning. ever since then the left nozzle has been massively misaligned.

Any ideas what would have caused this and how i can rectify it?

Thanks!