Printer randomly rebooting when printing, can reproduce by using Jog on Y axis

[Horendus]

I just swapped the right extruder Steppe motor with the Y axis motor and it made zero difference.

I will now try you suggestion Mjolinor!

Thanks!




UPDATE 1
I just cut all the steppe motor cable ties and re cable tied them individually to move them away from each other

I then went into JOG mode and ran Y axis up and down 2 times, it then started to do the little stutters....follow by a lockup of the printer. It then rebooted moments later.


UPDATE 2
I just re uploaded the latest firmware (sailfish) and ran the JOG test again. It still locked up the printer when moving the Y axis HOWEVER the LCD displayed an actual error. PLATFORM FAILURE!

Anyone familiar with that error? I cant find anything on it....?