Results 1 to 2 of 2
-
02-28-2014, 06:51 PM #1
- Join Date
- Feb 2014
- Posts
- 9
Computer advice for large 3D models
Can I get some advice on the kind of specs needed for a computer to run large 3D models of structures for 3D printing.
The structures will have 100,000+ rectangle units and trying to design this has crashed most (low end spec) computers I have thrown it at. Can anyone give me a rough idea? I'm assuming I need something with high CPU and GPU power, correct?
-
03-01-2014, 03:39 PM #2
- Join Date
- Jan 2014
- Location
- Oakland, CA
- Posts
- 935
Yes. Get lots of RAM and a good graphics card too, while you're at it. What's your budget? What programs are you trying to run?
Andrew Werby
www.computersculpture.com
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery