Good to hear but if you selected the QIDI Tech as the profile it should have been set up.

One tip. Watch the lower left for a status of saving to the SD card. Give it plenty of time to finish.

If you are interested I started a group on facebook called QIDI 3D (I think that is it!) check it out and be like one of the first to join.

Also have one for the Flashforge printers called Flashforge 3D.

Quote Originally Posted by Giandroid View Post
I found out where to enable it! It is in the "scripts" tab in the process settings. Mystery solved! Thanks again for all your help and prompt replies- I wull get back to you about my first prints.