Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Hybrid View
-
03-11-2016, 11:16 PM #1
- Join Date
- Feb 2016
- Posts
- 11
Thanks, yes, the bed is the biggest problem I see, too. I'm playing around with that this weekend. I doubt I'll find an easy solution but maybe there's something to be done there. Despite its flimsiness it seems to hold level for a very long time and the ringing on direction changes isn't bad and can be dialed down with software. Hoping to try some hardware solutions.
-
03-11-2016, 11:32 PM #2
I have this designed, getting pricing this week.
QidiZ v9.jpg
-
03-21-2016, 12:15 PM #3
-
03-21-2016, 02:32 PM #4
Yes, I have parts ordered, Enough to make 4 kits for now to test. The platform is 5mm solid carbon fiber plate. I have moved the adjusters to the corners of the plate to remove the teetering, It uses 10mm bearings. I might switch to 12mm rods and bearings, but 10 should be good. I will have it in two flavors. One where the buyer prints their own top and bottom mount and one where I will supply it. At least that is the plan for now.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help