Qidi Tech 1 - Replicator 1 clone

[cncartist]

All installed and up and running it only took me 7 ours but that was with doing other stuff as well.
Just a little bit of fine tuning to be done but that will have to wait until tomorrow.

I wanted to take photo's so i could show how the install went but i got exited and didn't take any.
Will post pictures of the finished install tomorrow.

Nice, it's worked out well for me so far and I like not having to level the build plate so extensively after a long print.

So, I will do another one with improved infill (it's disturbingly light), but I have to admit that the holes I'm getting up top are new. I've got seen that on any prints before.

IMAGE

I would expect my "Top solid layers" setting in S3D to cover that, right? It's set to 4, which one would expect to be enough layers. Wouldn't it?

I use 7 top/bottom by default for all my prints and will go to 10 or 11 top/bottom to achieve water tight seals. 4 seems a little low and I would recommend bumping it up if it isn't a part which depends on tight tolerances.