Is the parts cooling fan coming on. I had this recently that it was set to come on and I didn't realize and the left side of an ABS print lifted. Turned it of and redid the part and it was fine.

One thing I have done is add a PEI sheet to the glass and it has worked out pretty good. Take s a bit to get used to but haven't used spray or glue for a while now.


Quote Originally Posted by Merijeek View Post
Yeah, I haven't tried the slurry method yet. However, with the AquaNet I've gotten it to about 3cm without it getting knocked loose. I'm using lefty.

Of course now I'm hitting the OTHER ABS issue I've bad in the last. This isn't a problem at the beginning, but the left edge of the piece (basically oval footprint on this thing) is starting to curl up from the bed.

I so hate ABS right now.