Quote Originally Posted by sygyzy View Post
Can you take a picture of how it attaches to your case on the end opposite the endstop and motor? From Thingiverse it looks like you have to drill and screw a few inches up the side. But on yours, I can't tell how it ends.
On the Qidi I used an existing hole about 1/4 of the way up for the mount. On the CTC I drilled a hole lower since it's plywood. I like how the chain on the CTC lays and think I may drill a hole lower in the QIDI so it lays the same. The CTC mount is nearly as low as you can go just above the bottom deck.

Ideally if you read the older clone forums the ideal X axis cable routing is coming out the right rear corner of the machine. This is so you can move in RF generating cables away from the display. To help minimize the RF scramble of the display. As you can see I didn't do that.