Qidi Tech 1 - Replicator 1 clone

[wachuko]

Well... I need to research more the configuration of Simplify3D for this printer.... AND was not aware that the simple software that comes with the printer, already has raft/support capabilities...

I need to look up all the setting currently in ReplicatorG and use those to start the configuration in Simplify3D

Trying the same part again... with ReplicatorG and Support enabled...

[wachuko]

This is the part that needed support and failed because I did not know how to enable it... printing it again:

Simplify3D would show you the support on a different color... ReplicatorG does not show the supports but they do come out (tested a smaller part last night and it worked great).



And just a quick video with the printer in action: