Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Hybrid View
-
07-05-2016, 10:35 AM #1
I'm inclined to agree, the more I look into it the more I think it's a firmware rather than hardware issue.
For what it's worth regarding the firmware resetting a couple of pages back. I've tried it today, it's seems to make no difference. Just what you'd expect it to do, back to how it was when the printer arrived.
-
07-05-2016, 11:27 AM #2
- Join Date
- Aug 2014
- Posts
- 627
-
07-05-2016, 12:05 PM #3
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-05-2016, 12:13 PM #4
- Join Date
- Aug 2014
- Posts
- 627
That is what PWM basically is but it has a timer to do it right. Apparently Sailfish can't do it. It can't even do it for the HBP according to the comments in the source code so they made a kludge of using only 1 bit and it seems to work (I never looked at the nozzle section but if the HBP doesn't have real PWM and the Fan doesn't have it I bet the Nozzle doesn't as well).
Too bad Marlin will not work with a Mightyboard.
edit: So much for getting my MG PETG as my Post Office decided not to deliver it today even though it has been here since Saturday and says it is out for delivery. I ran down a carrier but they aren't the one who delivered to my address so my package, for right now, is in limbo.Last edited by DarkAlchemist; 07-05-2016 at 01:02 PM.
-
07-05-2016, 02:43 PM #5
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
The new QIDI printer has shown up on Amazon.
"Item model number: QDTHXO20160705"
The model number seems rather current. (Shades of THX-1138 too?)
https://www.amazon.com/QIDI-TECHNOLO.../dp/B01HZ4HY9I
-
07-05-2016, 02:53 PM #6
- Join Date
- Aug 2014
- Posts
- 627
-
07-20-2016, 01:51 PM #7
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials