Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 4110

Hybrid View

  1. 10-03-2016, 01:14 PM #1
    Syd_Khaos
    Syd_Khaos is offline
    Engineer-in-Training
    Join Date
    Feb 2016
    Posts
    360
    Quote Originally Posted by jfkansas View Post
    Not too bad for first try. Had 2 of the 4 fail, must not have got the 2 parts mixed good enough.
    ~pic snip~
    Very nice, I bet your nozzles will get to operating temp much faster.
    How much did ya pay for the goop?
    Reply With Quote Reply With Quote
  2. 10-03-2016, 01:24 PM #2
    jfkansas
    jfkansas is offline
    Super Moderator
    Join Date
    Apr 2014
    Location
    KS
    Posts
    907
    Add jfkansas on Thingiverse
    Quote Originally Posted by Syd_Khaos View Post
    Very nice, I bet your nozzles will get to operating temp much faster.
    How much did ya pay for the goop?
    It was a starter kit, and is about $60. Might make some for the stock hot ends for FF and QIDI.
    Reply With Quote Reply With Quote
  3. 10-03-2016, 03:59 PM #3
    DaveB
    DaveB is offline
    Engineer
    Join Date
    May 2016
    Location
    Annapolis, MD
    Posts
    523
    Quote Originally Posted by jfkansas View Post
    It was a starter kit, and is about $60. Might make some for the stock hot ends for FF and QIDI.
    https://www.amazon.com/Mold-High-Res.../dp/B00IZNNIU8

    Similar to this one?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules