Qidi Tech 1 - Replicator 1 clone

[wachuko]

Finally did some runs with PLA... works great. Not sure if it is the difference in temp of the bed/platform (ABS=110, PLA=50) or what... but the parts come out much nicer. I printed a few parts in PLA that I had already printed in ABS to compare the two.

[amiedd]

Finally did some runs with PLA... works great. Not sure if it is the difference in temp of the bed/platform (ABS=110, PLA=50) or what... but the parts come out much nicer. I printed a few parts in PLA that I had already printed in ABS to compare the two.

I noticed on the Qidi printer it says heat settings should be ABS 100c and PLA 50c when i printed something in Simplify 3D it set the ABS to 200c by default, does anyone know if that is ok, or should i lower the temp in Simplify 3D to what Qidi suggests? Thanks!