Improving quality of my prints? Newbie help.

[jfkansas]

First, if you're looking to minimize your filament usage on tuning, you might want to pick something smaller.

Second, I think you may've forgotten to upload an image. Which would be helpful.

That print is way smaller than it looks in that photo. 50mm x 50mm which is a couple inch square.

Definitely over extruding.

[AmyInNH]

It looks like over extruding, but that (alone) wouldn't account for the space around the circles, star, etc.

Take a look at this, the second photo looks like your print. It may be one or more of your belts are loose: http://support.3dverkstan.se/article...uide#wallspace