Results 1 to 10 of 15
Threaded View
-
02-26-2016, 07:20 PM #15
Oh god...
That's the worst failure I've seen of a printer (no fault of yours!) I have had a twist halfway through a spool before, but because of the way the flashforge is designed, if this happens, yes the roll goes tight but eventually the gear just eats through the plastic and then it snaps when theres not much left... but to actually remove the entire gantry, holy cow!!!!!
"Just check that the filament can feed freely before printing" is shit advice from them, because you can't see beyond one or two layers into a spool!Hex3D - 3D Printing and Design http://www.hex3d.com
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery