Any Problem Contact Me

[24c]

Alfred_technical_support,

I'm using v1.7 and just doing a turntable test scan, and the offset is much bigger than I remember before.
A quick look in Einscan-S>ini>calibrate setting file using Notepad, and the yoffset=55, so I changed it to yoffset=60 and it was even worse, so I tried yoffset=50 it the opposite way to your recommendation and it was better. There is another offset value above this line, offset=2, so is this the reason why I don't see all the model or do I need to increase the offset=50 to 52? What does this other offset value do?

Mike



offset-55.jpgoffset-60.jpgoffset-50.jpg