Quote Originally Posted by sl33pydog View Post
Is it normal for about 3mm of the model to be cut off from the bottom of the turntable up? Every scan I have done so far the model gets chopped off even when I have the object straight up with no inside pockets. For example when I scan a bottle of wood glue, everything from under the barcode is chopped off. I have the spacing correct to the mat and the angle as shown in the video. Is this a calibration error? Should I run it again?
About this, we set a cutoff plane, and anything below it will be deleted.
In order to avoid dirty on turntalbe.
Maybe the setting of the height is too big, but you can adujst a setting.
Please follow this:
1,find a file called calibratesetting.ini with this path: C:\Einscan-s\ini\
2, find a line :yoffset=50,
3, change the number to 54,
4, save and exit,
rember to colse software,before do those above.