for those that like a read heres a quick catch up http://3dprintboard.com/showthread.p...g-to-glass-bed

so now thats out of the way, onto what the topic states, the PRINTinZ Zebra Built Plate

i can say i was sceptical, i mean how easy did we think it would be to just put it in hit print and boom perfect printing every time, like the videos show.

well i was wrong, it is that easy, this plate is by far the single best purchase you can make, i have had 0 thats right 0 failed prints all perfectly stuck while printing, then just flex the plate and off it pops (well not always, even the video states that).

so there is a bit of setup required, a new z axis shim (1.75mm) to allow for the xtra plate height, a new corner clip system although all you actually need is clips to stop it moving about , then setting up the temps, when it says 0 heat with pla it means it.

after that just print and go.

will post pics when i have a free sec, mite even post a video or 7