Tests, advices and tips

[24c]

Another great scan, Dave ... :

If you have tried scanning fins with the Einscan-S,...

I've just tried that from the turntable, and results are mixed at the moment, it was Ok until it meshed it into a cube like form!
I've also attached the tripod and trying that from the turntable after calibration. Just playing at the moment.
So these are magnets and matt grey balls on the end of the studs, over holes etc?
Impressed
Mike

[Nerv]

Hey Mike,

I suggest stop using the turntable, I'm sure it has a use (calibration), but not for any serious scanning.

Hughes, the decimation was in Meshlab. SolidWorks has the same method build into it's Scanto3D add-in, but Meshlab is faster. Having said that, SolidWorks can break your mesh up by curvature, and then you can run that algorithm afterward in an effort to isolate and preserve any really sensitive meshes you want untouched (like holes).