Quote Originally Posted by richardphat View Post
Why after watching the 3 link, it does not feel 200mm/s print?


Because for me it is clearly between 50 to 100mm/s. The perimeter print is too slow for being 200, can't say about the infil, since the thickness is not that big.


But I am curious about your double extruder setting, did you use paper to calibrate both height?


Oh and dont upload pic on this forum, cuz it sucks lol. Upload on some 3D party hosting and link them, it is far better.
Hi, Richard

I calibrate the left nozzle with a card, and the right nozzle is a little higher than the left one, about 0.1 mm higher, I judge it with eyes... and it works good.
When printing with dual filament, the 0.1 mm higher right nozzle works as good as the left one, and it won't impact the object.