Results 1 to 10 of 10
Thread: Trouble with Slic3r calibration
Threaded View
-
07-10-2015, 03:44 PM #4
- Join Date
- Jan 2014
- Posts
- 462
The left is over-extrusion without doubt. Are you printing inner perimeters first or outer? Each perimeter will overlap the others so that you get good adhesion horizontally, so you might expect some pushing out if you're over-extruding a little. I'd try dropping the extrusion multiplier by 0.2mm incrementally on successive prints until you get a good wall.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help