Things that still suck about the V1 printer - according to the founder

[IDefINIte]

Feign i did assume the water was going to float ontop the resin. That was wrong. i didnt not assuming the water dripped ontop but in the middle, and unevenly. the bubbles are poppping out in random ways building a larger mass which now im thinking pops out underneath. id assume the resin traps the bubbles sometimes making the holes in the prints. wich might be dead by now. there hasnt been many posts.

they could try an egg beater test and pouring wating into resin from a pitcher. probably simple enough to see it trapped or not.

since i dropped in this babble and iv had the working of this printer wrong the whole time i guess ill just ask here. how do i start a print with this thing? if theres a 1/2 inch to an inch of resin floating does the printer just uv cure through plastic to make a base of standoffs?