Hey IDefINIte,

As far as I know from the Updates and Videos, the print works as follows:
(With a small sketch; probably one of the worst pictures I've made so far but it shows what I want to show)
PeachyPrinterSketch.jpg
You have a Tank containing some salt water and a wire mesh.
There is a tube going down into the water at the side for the drips.
You put a layer of resin on the water.
You start the dripper and the print.
As the water starts to raise, the printer prints a support structure that encloses the mesh.
Once the top of the layer is above the "grill", the printing of the object can begin.


Cheers,
quertz