Originally Posted by
rylangrayston
1. Sometimes we still get holes in our prints.
hacker solutions - slow your print down, help us figure out why this happens.
long term solution - start doing r and d to the resin.
2. coil wires are finicky and can break off
hacker solution - solder your coil connections, when coil wires break unravel the wire and make a new connection, buy a new coil They will be cheap.
Long term solution - we want to put coils on there own pcb daughter boards, so they just plug in with a ribbon cable
3. some parts are very small and hard to assemble
Hacker solution - tweezers + patients goes a long way, oh and we are sending some extra parts in case they fly out of your tweezers
Long term solution - pre assemble some parts that are tricky for people to build.
4. salt water and hoses are messy
Note: we have done alot to improve this already, its alot better than our beta units, but could still be better.
Hacker solution - Put a towel down on your work bench and do all your printing on that towel.
long term solution - developing a sealed dripper that is very easy to take apart and clean might help, so would a pump.
5. Calibration features are needed for accurate prints
hacker solution - .... umm... dont print things that require accuracy
long term solution - build the features and do a software update.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials