Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Threaded View

  1. 06-22-2015, 09:20 PM #4
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Oops. I had my threads crossed. The Z motors and M5 threaded rods have nothing to do with the retraction speed. My testing indicated the extruder motor would top out between 15 and 20mm/sec before it would start to skip.
    Last edited by printbus; 06-22-2015 at 09:39 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules