Results 1 to 10 of 74
Thread: Free build plate!!!!
Hybrid View
-
06-09-2015, 02:31 PM #1
- Join Date
- Jun 2015
- Posts
- 34
well its untested in those conditions so im am very interested to see the results
-
06-09-2015, 02:46 PM #2
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
The problem I have is not one of sticking, it is sticking too much. I do not suffer form warp at all ever but I break a lot of stuff getting it off the build plate. I currently use polycarbonate but have to replace it regularly, once it gets scratched you cannot get stuff off it.
-
06-09-2015, 04:10 PM #3
- Join Date
- Jun 2015
- Posts
- 34
when you finish your print, remove the whole bed and put into freezer for 30 minutes, that should shrink the print faster than the bed and therefore it should just pop right off on its own.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion