Quote Originally Posted by Chadd View Post
Try these settings in S3D

Under the extruder tab under Ooze control

Check mark Retraction, Coast at End and Wipe Nozzle

retraction distance = 3.00mm
extra restart distance = 0
Retraction Verical Lift = 0
Retraction Speed = 15
Coasting Distance = 0.20
Wipe Distance = 5.00


Under the Advanced tab under Ooze control Behavior

Check only

Force retraction between layers
Only wipe extruder for outer-most perimeters

Leave the rest unchecked
I have tested your settings and the cylinder is not 100% perfect it is really close to what it was previously. The inside layer change blobs are a lot better but on the oustide you can see the same issues as pictured on the original post.