Mounted the bed properly, added part cooling fan and wired them properly. After leveling the bed and a couple of test prints I got this benchy printed:

2019-03-31 16.58.55.jpg2019-03-31 16.59.00.jpg2019-03-31 16.59.18-1.jpg

Looking quite good.

Had some jamming problems on the first try, reduced retraction a bit and added filament oiler, no more jams. Also other Z-motor was binding occasionally due to the coupler being just a bit too tight fit, fixed that by wrinting some g-code to move the bed up and down and using a file to smooth out the coupler while moving.

Need todo something about the wiring next and also mount the PSU to the frame.