I read about Meshmixer I tried useing it on my computer turned out my computer is far too old to run it. I have a old 2006 32bit Macbook Pro even the oldest versions won't work.

I think it will be super important for the peachy printer to work with all older computers both 32 bit 64bit as well as Arm based computers such as the Raspberry Pi and Android devices.

A custom slicer that is made for the Peachy would defentally help eliminate the guessing of support structures and. Because FDM support structures might not work too well for the Peachy.

Also the thiner the support structures are with snap off points will help save allot of resin too.