Quote Originally Posted by old man emu View Post
As I write this, I have my print bed heating to 115C and I am going to wait for about 30 minutes before I go out to start a print job. Current ambient air temp is 27C
This attempt was a monumental FAIL. I got corner left on a rectangular 30mm x 45mm x 6mm block , and for some reason, the gear that I was trying to print at the same time just came out as a rough edged column of ABS squiggles.

I read some stuff on the madesolid site. They suggest a coating of PVA glue on the glass. I'll give that a try.

Can you run 1.75mm filament through a 3mm extruder? It seems that 3mm filament is going the way of the Dodo.

OME