Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 30

Thread: 10" Y Plate

Hybrid View

  1. 05-08-2015, 05:56 AM #1
    PyramidDave
    PyramidDave is offline
    Technologist
    Join Date
    Nov 2014
    Location
    Brevard, NC
    Posts
    182
    I found where someone had posted a dxf file of the complete i3v 12" makerfarm which appears to be scanned in. I will use that as a guide for adjusting this to 12" & repost it for your review. I can not find the post where I found that before on this site & did not make a note of who posted that.
    Reply With Quote Reply With Quote
  2. 05-08-2015, 07:28 AM #2
    voodoo28
    voodoo28 is offline
    Engineer-in-Training voodoo28's Avatar
    Join Date
    Jan 2015
    Location
    South Florida - Cooper City
    Posts
    212
    Dave I think this is the file you are referring to?

    i3v1204.dxf

    Quote Originally Posted by PyramidDave View Post
    I found where someone had posted a dxf file of the complete i3v 12" makerfarm which appears to be scanned in. I will use that as a guide for adjusting this to 12" & repost it for your review. I can not find the post where I found that before on this site & did not make a note of who posted that.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules