Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 04-01-2015, 03:27 PM #1
    mattanonymous
    mattanonymous is offline
    Student
    Join Date
    Nov 2014
    Posts
    32
    Do you see the large extruder gear trying to turn and hear it clunking? Does it start to move on its own if you help it along? If this sounds familiar, make sure the 2 long bolts on the guidler (the ones with the springs on them) are tightened and even.
    Reply With Quote Reply With Quote
  2. 04-01-2015, 05:43 PM #2
    markmark
    markmark is offline
    Student
    Join Date
    Apr 2015
    Posts
    4
    Quote Originally Posted by mattanonymous View Post
    Do you see the large extruder gear trying to turn and hear it clunking? Does it start to move on its own if you help it along? If this sounds familiar, make sure the 2 long bolts on the guidler (the ones with the springs on them) are tightened and even.
    That might be it, it will start to turn if I help it a little. Thanks.

    I'm thinking it has something to do with the filament getting stuck. I was able to finish a print so it's not consistent.
    Reply With Quote Reply With Quote
  3. 04-02-2015, 01:39 AM #3
    TechMasterJoe
    TechMasterJoe is offline
    Technologist
    Join Date
    Nov 2014
    Location
    Orange, CA
    Posts
    78
    Quote Originally Posted by markmark View Post
    That might be it, it will start to turn if I help it a little. Thanks.

    I'm thinking it has something to do with the filament getting stuck. I was able to finish a print so it's not consistent.
    this honestly sound like the peek insulator is not getting good cooling hows the fan mounted can you post a pic
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules