Results 1 to 10 of 16
Threaded View
-
03-28-2015, 11:00 PM #15
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
Depending of slicer, it the looping can at the same spot over and over again; you cannot change that. You can lessen the appearence by printing slowly, as opposed to traveling speed which is another thing and I won't go into detail since I am not a freak in this setting.
I usually print from 30 to 50mm/s
Depending on customers, z height ranges from .05 to .35mm
Try these settings, and tell me if it has change anything.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help