Vertical line on circular prints with Makerbot 5th gen

[richardphat]

The slicer just had failed on your cylinder.
This happens often with thin wall extrusion, fast print and on top of that if you ever print with high Z layer .

One solution to check, print one, but slowly with .1 or .2mm height AND try to increase thickness of the object itself.

[ch0g]

The slicer just had failed on your cylinder.
This happens often with thin wall extrusion, fast print and on top of that if you ever print with high Z layer .

One solution to check, print one, but slowly with .1 or .2mm height AND try to increase thickness of the object itself.

I had no luck with the ooze settings. The same thing has happened with any cylinder I print on both the 5th gen mini and 5th gen rep printers i've had.

Do you have any recommendations on speed while extruding and travelling in mm/s? default is 90/150

Thanks

[ch0g]

The slicer just had failed on your cylinder.
This happens often with thin wall extrusion, fast print and on top of that if you ever print with high Z layer .

One solution to check, print one, but slowly with .1 or .2mm height AND try to increase thickness of the object itself.

I'm noticing that even with slow extrusion of the outlines that the retraction is always at the same point on the cylinder. Is there anyway to change the same retraction point on the Z axis?