Vertical line on circular prints with Makerbot 5th gen

[Roberto]

Maybe you are using old print file, made from some of previous verisons? If so, reslice it.

What is left is Custom profile.
I don't know how familiar you are with it, but generaliy you have to increase distance between start and stop point of extrusion (during those circles).
To do so, is easy: just increase the value of "ozze" distance from 0.1 (factory) to 0.2
Make sure to do so at 2 placese of occurance of this parameter.
You will be able to notice difference even in Print Preview.
If still not good enought then maybe 0.3 .... etc.

I hope this will do

[ch0g]

Maybe you are using old print file, made from some of previous verisons? If so, reslice it.

What is left is Custom profile.
I don't know how familiar you are with it, but generaliy you have to increase distance between start and stop point of extrusion (during those circles).
To do so, is easy: just increase the value of "ozze" distance from 0.1 (factory) to 0.2
Make sure to do so at 2 placese of occurance of this parameter.
You will be able to notice difference even in Print Preview.
If still not good enought then maybe 0.3 .... etc.

I hope this will do

many thanks. i will run some test prints now. i noticed ooze and preooze variables, would you recommend changing both?