BBP Control Board - Speed Up Your 3D Printer

[adamfilip]

I dont get why this would be much better then a rambo board

[richardphat]

One big problem of 3d printer is the speed, people need to wait for hours to print a simple model. That is because the current control board, like RAMPS, Smoothie, are all powered by Atmel processors, whose frequency are too low to let the motor run fast.

Oh just freaking cut it, do you guys even know what the hell you're talking about? Don't you dare thinking us as brainless people...

[brbubba]

I dont get why this would be much better then a rambo board

I'm thinking niche application where people are developing printers that can actually hit higher speeds, although I haven't seen any in action.