Ditched all the extra insulation under the bed with the exception of one piece of cardboard. Got my Z height dialed in and bed leveled. Adjusted my Estops and got it close enough to dial in the rest with the Extruder multiplier. Printed a fan shroud to see how it would do and it looked decent. Went to print the 20mm test cube and the extruder clogged up again. This has been another issue I've been having is that I can't print back-to-back prints. I need to pull out the filament, clip the end and start fresh otherwise it clogs up. Anyone else ran into this problem before?

I am able to measure the sides of the calibration cube and I get 20.06 and 20.00