my Rep2X died today, well almost..
Have a Rev H board.
Ckd voltages, both 5v and 24v are good.
the LCD is OFF, shows nothing, not even back light.
On the mother board, the DS5 LED blinks, but there is no USB link for Makerware to perform an update.


Events that happened:
I made a build, then began to do the next build, and got an error, plate heat error, but the "error could not be found"
so I powered down and back up, still same issue.
I navigated the menu and did a Factory Reset, thinking this would get me back to a clean starting point
At this point the LCD went blank (dark) and the USB interface died.


I am somewhat convinced that the firmware is trashed an the bootloader may be also.
I've read about the winbot tools to allow you to reload the firmware.
does anyone know where to download the tools and also the REV 'H' firmware and / or Bootloader


also are there step by step instructions to perform the reload?


thanks chuck