so after some play in the glass bed, i realised the corner brackets wernt holding the glass still (im aware its due to the heated plate) so i redesigned them to fit tighter and also stop the z movement by introducing a 45deg bevel, this however cause its own unique issue of coliding with the hotend when it extrudes at the end of the bed before printing.

so i have now made clearence for this.

only time will tell if its any better or worse, but for now it seems alot better as there is no movement at all in the glass now. and yes they are still hot swappable as i retained the 2 rear ones in there original design.

corner_clips_preview_featured.jpg

here they are and heres the link http://www.thingiverse.com/thing:795832