Results 1 to 9 of 9
Threaded View
-
02-19-2015, 02:50 AM #1
- Join Date
- Feb 2015
- Posts
- 13
CubePro Trio support material in house project
Hi
I juts start using 3D printer and I'm struggle with support material... I noticed that its not easy to print something properly where is over 45 degrees or have many thin pillars. I seen that people cutting the object for few parts and glue them after that. I have small project (house) where I try to get a good result, but Im not sure If I will get a good result in this printer (because of limited possibilities) so I would be grateful if someone of you could check it and advice me how it would be best to cut it , to get good result
Please explain to me how to...
Today, 12:15 PM in 3D Printer Parts, Filament & Materials