Hexapod robot: T08A2 / R3000 spider lightweight tank (from GITS)

[PauliusLiekis]

Some photos from older printing:


"Find 10 differences!" or "My printer misunderstood what I actually want to print (correct piece is on the left side)":



"Tail":



The part is to big to make it as a single print - the max print dimensions 20x20x20cm. It was chopped into 6 individual pieces. The printer was misbehaving again a bit, so 2 out of 6 parts had to be corrected after printing:



Assembled:



I covered the bottom piece with too much acetone, which resulted in bends... I had to cut it, screw to the frame, glue together and use a lot of putty afterwards There is still small gap between the top and bottom, so I added a screw to tighten them together after closing. The top and bottom are not glued together, since main electronics sits there and I need to service it occasionally or attach screen and keyboard when coding for it.



Result:

[PauliusLiekis]

I found out that the old RaspberryPi (model B) is getting in a way of cables after assembling all printed parts, so I replaced it by newer model A+. Everything fits much better now:



This is how it looked before the painting of details: