Results 1 to 5 of 5
-
02-15-2015, 08:38 PM #1
- Join Date
- Feb 2015
- Posts
- 4
CTC 3D Dual Extruder and Simplify3d Software
My 3d printer prints fine using Makerbot. whenever i try to print using simplify3d, the ABS filament comes out slow and begins to clog up. Anyone using Simplify3d with a CTC3d printer? I think my FFF settings need to be tweaked but not sure what to do.
-
02-16-2015, 03:17 AM #2
I'm using Simplify3D too. I tweaked the values by experimentation. What I suggest is you go to your process page and put here screens of all the tabs and we can discuss that.
-
02-16-2015, 07:00 AM #3
- Join Date
- Feb 2015
- Posts
- 4
Here are the remaining settings.
-
02-16-2015, 08:08 AM #4
- Join Date
- Feb 2015
- Posts
- 4
I had to delete my original post because i couldnt edit it. "The message you have entered is too short. Please lengthen your message to at least 10 characters."
-
02-16-2015, 04:34 PM #5
Please :
1/ try to enlarge a bit
2/ I think the most important would be to display your extruder temp tab as well as be temp tab and finally the tab with all the speeds.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help