Subscribe to Our Newsletter Advertise
Close



Results 1 to 5 of 5

Hybrid View

  1. 02-11-2015, 01:37 PM #1
    Cameron
    Cameron is offline
    Student
    Join Date
    Jan 2015
    Posts
    48
    Z axis cable is probably backwards. Just flip it to the opposite where it plugs into the ramps board.
    Well that is if I am understanding your problem correctly.
    Reply With Quote Reply With Quote
  2. 02-11-2015, 01:49 PM #2
    abuharsky
    abuharsky is offline
    Student
    Join Date
    May 2014
    Posts
    16
    Quote Originally Posted by Cameron View Post
    Z axis cable is probably backwards. Just flip it to the opposite where it plugs into the ramps board.
    Well that is if I am understanding your problem correctly.

    I'm not sure.
    The fact that the printer worked fine last few months without any changes to the settings, firmware and mechanics.
    Until yesterday, when it was trying to self-destruct raising Z up when Z position already at MAX.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules